![]() ![]() %Portfast has been configured on FastEthernet1/3 but will only When portfast is enabled, can cause temporary spanning tree loops. %Warning: portfast should only be enabled on ports connected to a single host.Ĭonnecting hubs, concentrators, switches, bridges, etc.to this interface SW(config-if)# spanning-tree portfast < Optional Now lets move to Cli where I am going to show everything into 2 Important Steps:īTW, I used a Cisco 3725 Router with 16 Port Switching Module to emulate the Switch part here so some of verification and configuration commands are specific to this setup as here Router is acting as a Switch.Įnter configuration commands, one per line. Now before we move ahead, for those which are not familiar with these two topics (Ether-Channel & Router On A Stick), I would recommend following Pre readings :
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |